Couple of questions
1- If you have more than one AMS, and ht and you have AMS AUTO-REFILL check will it pull the refill from another ams as long as it is the same type ie pla, generic, black ect?
2-I understand that you need to do this prior to sending the print to the printer, I refreshed the filaments in the slicer, sliced it then sent it to the printer. It told me that it was going to draw out of ams-b slot 4 which was the one that was going to run out. I placed the refill in the ams-ht and verified it visually just prior to after slicing and hitting the print button, but it failed to do it?
What am i doing wrong?
Both filaments were set up on the h2c and refreshed in slicer as GENERIC, PLA BLACK
Thanks
Steve