3rd time it is then… 
Did you even read the example I gave? lol
I’ll re-quote it here:
/start of pleading
Machine: P1S + AMS
Stock SD card: Yes
Bambu Lab Slicer Version: 1.10.1.50
P1 Firmware version: 01.07.00.00
Approximate layer number where it failed: approx 790 out of 922
Approximate time elapsed between print start and failure: 18 out of 19.75 hours
This was devastating. I was printing trophies for a tournament I ran that day… showed up with a frown instead.
BAMBU LABS WHAT CAUSED THIS
/end of pleading
This user is using stock everything…
How do you purpose it could have been caused by 3rd party whatever…
Read the thread… and the other thread dedicated to the same issue…
Look at the reported setups… 9 out of 10 of them are “normal” users with stock setups. No 3rd party anything.
3rd party stuff is not causing the majority of issues on this forum.
We… the users you complain about… are the ones trying to help the “normal users”… not BL support!
Like most newer users to this forum should do (most of the answers are here)…
Read before you post please.