Another mysterious Layer Shift

Bambu Lab X1 Series Troubleshooting
1

Hello friends.
My printer is new, and other models with the same filament printed pretty good. This is the first bigger print and at 80% it failed. The spaghetti detection worked fine! :slight_smile:

I used the standard profile for eSun PLA+ with eSun ePLA ST (Tough) and supports.
As already said with smaller prints this worked perfect.
Suddenly a layer shift appears with an Y-offset of 19.12 mm and an X-offset of 14.98 mm.
Now I don’t know what I can change to resolve the issue.
Any help is appreciated.
Kind regards
Roland

Layer_Shift1
Layer_Shift11920×3415 580 KB

Layer_Shift2
Layer_Shift21920×1079 187 KB

2

Was manchmal klappt ist, das Modell nochml neu zu slicen. Evtl. einen Milimeter versetzt, falls das geht.