As the title states I wonder if Bambu has any plans to release a hotend capable of printing PEEK filaments.
2 Likes
I’m wondering same thing for peek and ultem???
Me too 400-420C would be nice to have. I found a hot end for bambu 500C resistant but Firware/Power and etc . Any one used this from 3dprinteraccessories shop the upgrade-hotend-kit-for-bambu-lab-x1-p1p-3d-printer-high-temperature-resistance-500 ?
The melting point of PEEK is usually 341°C to 343°C (about 646°F to 649°F). There is no PEEK variant that has a melting point below 300°C, so the built-in Bambu hot end can only melt up to 300°C.
Source: Temperature Ranges of PEEK
Is there any experience with a non-Bambu original nozzle for the P1S?
3DJake, for example, offers a hotend with a maximum temperature of 400°C. As there are installation instructions, I assume that this will work.
(Edited)
Slice Engineering: Mako Hotend for Bambu Lab P1P/P1S, Gamma Master FIN Nozzle
Item no.: BTE-HOT02MAK41550, Ca. 124 Euro
