All my P1Ps are down because the new firmware doesn’t allow the heating bed to start. I can manually enter 70 and it shows “heating” but it stays as 19 or 20, I’ve tried this on all 3 and got the same results, My X1 works fine but there was no firmware update on this one.
Just tried it with FW 01.01.00.00 on P1P … entered 50 degrees C, it heats up and shows temp in Bambu studio on PC and android. Entered 0 and it cools down again.
1 Like
Just tried again on my p1p and one of them does work, but the other too does not heat up, I’m really confused but I don’t know if it’s just a coincidence since the firmware update or something else, one I can understand, but two of them at the same time?