Auto reprint g code

Emre1 · December 3, 2024, 9:31pm

Hi Guys,
I want to reprint my gcode as automaticaly my a1
this is my test gcode:

G28

M23 model1.gcode
M24

all axes go home, then nothing happens. Where am I doing wrong?

JonRaymond · December 3, 2024, 9:35pm

Probably because M23/24 isn’t supported.

The most extensive list of Bambu supported gcode I know if is here.

github.com

jphannifan/x1plus-testing/blob/main/Gcode.md

# Gcode Commands for Bambu X1 Printers


## Overview

This wiki provides documentation over BambuLabs Gcode, specifically for the X1 series. A majority of these commands work on other Bambu devices, but we have not tested on other devices. Several of these commands are being documented for the first time, and please take caution when using them. See below for information on the commands that X1Plus uses. 

## Table of Contents
- [Overview](#overview)
- [Homing and Positioning Commands](#homing)
- [Temperature Control](#temperature-control)
- [Movement Commands](#movement)
  - [Linear Movements](#g0-and-g1)
  - [Arc Movements](#g2-and-g3)
- [Coordinates](#coordinates)
  - [Coordinate system commands](#coordinate-commands)
  - [Useful Coordinates](#useful-coordinates)


## Identifying Gcode format and parameters

This file has been truncated. show original

Emre1 · December 4, 2024, 5:24pm

@JonRaymond Thank you for your answer. I looked it but no solution