Has anyone here experimented on removing the print remotely by moving the toolhead via the app? I have been considering it, because it would be very nice to just get it off the heatbed when it is done and cooled down. As long as the print is not using the last 2 cm in the back, or in the corners or …

You probably could go into the g-code and have it wait for the PEI to cool then hit it off. As long as you wait for it to cool fully I see no issue with it. If you do end up trying let me know how it goes!

I found an issue, after trying to do it manually via the app: My printer is on the very side of the table, and the print will likely fall off and hit the floor. It made me wonder if it is possible to make a gcode file that can be “printed” just like any other file, but without homing and doing all o…

I have just tried this remotely from my desk at work. my print finished hours ago, so is well cooled now, but for some reason when i move the bed to knock off the print it wont move once it tocuhes the toolhead

Did you see this? There are a few versions for the A1 Mini only out there. [image] Automation for A1 (3D print farm) General Discussions Automating 3D Printing with Plate Swapping I’ve been working on an exciting mod for the BambuLab A1 that can automatically swap th…

And this one is ready to purchase I believe: [image] Multi plate automation for A1 mini General Discussions Our paper printer can print multiple pages. Why shouldn’t our 3D printer be able to do the same? This October I launched the swapmpd – a multi plate aut…

Hi, you can go multiple approaches. For instance add it to engcode directly and it will be executed by default after print ends. Just make sure to add a gcode wait-command before starting clearing-code. Unfortunately you can’t controll it by temperature on BambuLab printers (at list I failed trying …

…and yes, swapmod is finally available for preorder at swap-systems.com :grin::shopping_cart:

Do you have the gcode for this for the a1 mini?

no, have not tried it on A1 mini.

Just make sure to not end up like me and force any of the hot end against the print or boundary or you’ll end up with a broken axis motor.

Automatically remove prints with the toolhead

Bambu Lab A Series

Voltage December 4, 2024, 5:00pm 5

Did you see this? There are a few versions for the A1 Mini only out there.