I have my Bambu Lab A1 for some weeks now and noticed the following: Problem: Before each print Bambu Lab A1 appears to attempt to feed filament while the nozzle is still cold. When I upload from Studio to the A1 printer then before the print starts, the print head is moved somewhere high up, to t…

Hello Davinciano the clicking is perfectly normal. As you mentioned it happens 2 to 4 times as the print head is homing at the start etc thats ok. its a check that the extruder does. If it clicks anymore or at another time during the print that is a problem

[image] New A1 skipping extruder during prep phase of print Troubleshooting Hello. My A1 did the same thing, and I commented out the 2 digits in the gCode. However, I have always wondered what these 2 steps are supposed to do and what Bambu Lab was thinking. For anyone w…

Thanks. See my response in the linked thread.

Bambu Lab A1 attempts to feed filament while nozzle still cold

Bambu Lab A Series General Discussions

Dominik.W September 28, 2024, 11:20pm 3