Hello I am currently running into issues that my commissioned print is failing repeatedly due to not adhering to the bed I have cleaned/flipped adjusted heat ect but it will fail 90% of the time I have including some photos that the STL will not adjust with the raft be it 1mm or 100mm it stays the same size with or without supports while the other picture shows that a different STL can adjust just fine. Is there a way to fix this STL or fix the bambu slicer that it will adjust the raft when its set to the different MM I have gone though 3/4 or a roll of filament so far just trying to test different options, I am trying not to lay it down due to keeping the surface free of rough spots and saving time with sanding and also letting me print 6 at a time vs 3… any guidance would be helpful
1 Like