Bambu Studio Tree Support

Bambu Lab Software
1

I’m trying to use tree supports in Bambu Studio and I’m getting strange results. The first picture below shows the last tree layer before a solid layer is laid down in Cura. The second picture is Bambu Studio. The Cura tree support branches out into a dense, fine support base for the next layer. The Bambu tree support is very sparse. Is there a setting that I’m missing? I’ve tried various options but I can’t get anything like the Cura supports.

Thanks,
Randy

Tree-CU
Tree-CU800×669 392 KB

Tree-BL
Tree-BL800×720 251 KB

2

I have found all automatic generation of Tree supports to likewise be very lackluster and requires much manual adjustment, or complete manual placement altogether.

I’ve run through various slicers in the past for years, from SLS to FDM slicers and this support generation is the absolute worst I’ve ever seen on it’s stock settings.

3

Kallvin,

Thanks for the reply. Have you been able to manually adjust to get results like in Cura above?

Randy