@user_4272229241 you do have a good point. @flint723 mentioned heat creap so I looked it up. I did some temperature reading inside with the furnance filter on and it did get up to 34 Celcius at the top. I am now leaving the filter off. With the filter off the containers should still keep the down draft from shifting the temperature to much.
I haven’t had to change any settings. Though Yesterday I did have an issue with warping ( PLA ) on a object that had a large flat bottom surface and that was even with brim. Going back to using glue sticks again and I am going to trying to lower the bed temp as well. I am going try your suggestion as well of having no cooling for the first 3 layers @user_4272229241
I am mostly using Elegoo filemant and found a great profile on the form here yesterday for the Elegoo High Flow PETG. I do believe it made a difference.