Black lever by camera keeps knocking off toolhead cover

Hello…

I’m about 5 hours into a 19 hour long print that uses the whole bed width. I have had to reseat the toolhead cover and restart the print going on 10 times now, because of this little black lever near the camera keeps bumping the cover off during infill movements. As you can imagine, this is making it quite hard to get to sleep, as I would like the print to finish, not pause every 30 minutes because this lever bumped the toolhead cover off.

Is this supposed to be there? Is this a design flaw? Am I stupid? These questions remain.

Help please.


A little searching on the BL wiki will get your answer.

2 Likes