I had something similar on my A1 mini. I scrubbed the daylights out of the texture plate then replaced the hot end .04 with hardened steel and the sock then scrubbed the plate with alcohol wipes and now it prints fine with a now and again failure. The tram adjustment etc made no difference. I’m going to replace the plate with a new textured one and I’ve added the Bambu glue to the mix as well. My hobby niche is quite small, abt 8x12 so I have also started closing the doors and closing the heat/AC register vent (that has made a noticeable difference). Hope this gives you some ideas
1 Like