Brim/ skirt/ raft settings for tree supports

[Scally123]

Hi all,

I’m a bit lost and wondering if this setting exists. Is there a way to adjust the brim width or the number of brim layers specifically for tree supports? Also, can I control the amount of brim layers for tree supports separately from the main print?

I’m trying to improve bed adhesion without placing tree supports on the model itself. Ideally, I’d like the supports to reach out from the build plate rather than being directly on the print.

I tried printing, but three hours in, the tree supports fell over. Any advice on settings or bed adhesion techniques to prevent this?

Thanks!

[Neiljt]

There are raft settings , that may be able to help

supports can be set to build plate only

[Scally123]

ahhh Thank you! I think Tree Style Strong increases number of Brim/ Raft Layers