Anyone had the drying task run-on?
Recently set a PETG drying task from the touchscreen for the 2 Pro and left it running.
At the same time I started a AMS HT drying task for TPU from the touchscreen.
Tasks were for 6 or 8 hours, can’t remember which but it was at about 0100hrs so they should have been finished by 1300hrs the following day.
The HT task finished because I used the filament and I know the LCD timer was reading 0.
The 2 Pro task didnt stop.
I noticed the Assistant warn about drying and printing but ignored it (I’ve had this not clear until a hard reboot before).
After a print I noticed fans still running. It was the 2 Pro.
Opened the drying dialogue in Bambu Studio, the drying stopped, then showed me the regular status screen.