Why can’t I unload the extruder after a manual print (switch off the printer then switch it on again then it works?!)
1 Like
So, that’s what is going on. I thought I was going nuts. Had to unload with the handy app.
The new firmware fix it 
nice service !
I can happily confirm. Nice to unload without finding where I left my phone. 
Frankly on balance I would rather not have had this fixed because I never had a problem manually unloading and because of some stupid UI design.
I manually load filament. As soon as it hits the extruder I want to poke the extruder down button one or two times to grab the filament and now at about the same moment the UI decides to re-arrange the buttons placing the unload button where the extruder down button used to be so instead of grabbing the filament it goes through the whole tedious unload process.
One dumb piece of UI design.
Yeah… That’s how I found out they “fixed” the button. Doing a manual load, and immediately cut the filament while trying to extrude. Now that I know, I haven’t hit it by accident… yet.