Bug-report support not appearing where specified during slicing

[user_689367438]

bug-report

See here:

Forcing support where I need it

I’m going a bit mad… I have tried all the different types of support, auto and manually painting them on. I have played with the freehold angle on auto supports, removed “remove small over hangs” option etc etc. I just can’t get support material under all of this region circled in red, just as depicted in green in this slicing preview. This is a functional part (150gram combat robot shell) so I’m not worried about surface finish really but the uniformity of the radius of the curve is affected a…

support not generating correctly using Version 1.10.1.50 it is generating correctly using 1.9.2.57. No error msg was displayed, just poor support generation as documented in the linked forum thread.

[user_643167163]

I’m fairly new to Bambu and having similar issues with support. The auto support adds too much, and I can’t get supports where I want them using manual. Have you found any good information on this topic yet?