No problem with stickers on both sides, I have a few plates like this and they perform very well.
The only ‘issue’ is the handling.
Unless you put on gloves you will have to give the other side a decent clean if you want to print on it.
Do yourself a favour when putting stickers on and don’t rush it!
Spray some soapy water on the plate and sticker so you can align it properly, then squeegee out the water, starting from the centre and with more pressure after the first few rounds.
Place on the bed at 40 to 50 degrees for 2 to 3 hours or just leave it sit in a warm spot for a few days to let the remaining water evaporate.
Like that you won’t get bubbles, won’t end up with a mess and only wasted a bit of time.