Why is Flow Dynamics Calibration disabled? (X1C Printer) - I can’t figure it out
Most of the time, my Flow Dynamics and Flow Rate calibration buttons (both auto and manual) are disabled in Bambu Studio. Occasionally, the manual calibration button is enabled while auto remains disabled, or the Flow Rate buttons (manual and auto) are enabled, but Flow Dynamics is disabled.
I’ve double-checked that the correct printer (X1C) is selected, ensured my printer is connected on the network and selected on the Calibration screen, and tested both with an empty build plate and with a model loaded. However, I haven’t been able to identify any factors or changes that determine when some or all of these buttons are enabled or disabled.
I’ve scoured the Bambu Wiki, forum and Reddit, but most issues seem to involve users without the X1C. I haven’t found any posts describing the issue I’m facing. In my case, even the manual calibration options are often disabled, and Flow Dynamics is frequently disabled even when Flow Rate is enabled.
Does anyone know what might be causing this? Could there be a specific setup or condition I’m overlooking? I’m at a loss - this is very frustrating and slowing me down from getting my work done lol. Any insights would be greatly appreciated!