I ran the manual calibrations, neither printed correctly. How do I fix this? I have a P1S printer and have had many issues with it. All the lines in the flow rate section are broken and the sqaures in the flow dynamic are rough
Did you succeed in printing any of the pre-sliced objects on the sd card with the pla that came with the printer? Was it OK.
Attached are pictures and a short video of issues we are having. We used a .4 nozzle to run the manual test calibrations and the video is of the test print of the banchy boat from the usb card that came with the printer. We use bambu filament, green PLA.The AMS is unusable as the power keeps cutting in and out. We replaced cords and still have the same results.
/
