I’m setting up my new P1S with an AMS Hub and AMSes.
The only way I can arrange my closet involves mirroring the hub and inlet on the back of the printer vs what’s shown in this picture; facing the rear of my printer, I want the AMSes to feed the Hub from its right side, and to bring filament into the printer on its left side (again, “left” when looking at the back of the printer.)
Flipping the AMS Hub seems simple enough; I wouldn’t even bother with a bracket, just rotate 180 degrees, use the existing two mounting holes, and the hub is a little higher than shown here.
As for bringing the filament into the printer (presently at top right in the picture)…
It sure looks like there are an extra couple holes already present in the back of the printer asking to be repurposed to be a new location to bring the filament in.
Could I disassemble the existing input port and flip it to the left side where I want it to be?
Anyone done that? Any warnings??
