Clean ASA film from printer

Goo gods that stuff is nasty. I have not seen oily film buildup on glass - and obviously everything else inside - since I was a smoker then Vaping and made the mistake of doing it in my car with the windows up.

92% IPA is not doing the job. Smears and streaks worse than windex on a window. Pretty sure it is not going to clean the carbon rods that BL warns us about - though it may be acting like a lubricant…

What does the community use to clean up?

And, yeah, I am going to build an outdoor vent and poison the neighborhood rather than my house.

A BOFA 3D PrintPro 3 has worked extremely well for me (with an X1C) to suck out all of the nasty bits. I pipe the cleaned air back into the printer (roughly – I aim it back in the the vicinity of the poop shoot in a half-hearted attempt at retaining some of the heat.)

Not cheap, however…