Confusin Print Seam, its shown in Slicer Object fine

Bambu Lab P1 Series Troubleshooting
1

Hello dear community,

I have a problem that confuses me completely I hope you can help me
I have created a 3D model that does not show any errors in the mesh model but still as on the photo of the original print I see a depression which is displayed exactly as in the slicer where some strange knowledge is calculated.

I have already installed an older version of Bambus Studio which has this new technology turned off by default but still I get exactly the same error with the old slicer can anyone tell me what I am doing wrong.

Oh and the white seam (Imgae 2) is change if I rotate the 3D Model (face look up)

20241116_135502
20241116_1355021920×1794 126 KB

Screenshot_4
Screenshot_4727×809 294 KB

Screenshot_1
Screenshot_1803×836 114 KB

Screenshot_2
Screenshot_2614×611 210 KB

Screenshot_3
Screenshot_3620×547 242 KB

2

Learn more about seams and how to optimize them here: Seam settings | Bambu Lab Wiki

Basically - due to how printing by layers makes seams unavoidable, you have to optimize the seam setting yourself so that the seam is as invisible/unobtrusive as possible.

Also - consider moving the thread to Bambu Studio since it’s a slicer setting, not P1 specific trouble :slight_smile:

1 Like
3

The solution ist Paint Seam!

But onther Question will vase mode not working for
round parts to evade sems?