Cruise Ship Print

Just kicked off the Aurora reprint after some design changes follow seeing the actual ship. Back in June 24 on an X1C Cruise Ship Print - #157 by Ukdavewood
It took around 13.5hrs.

Initial expectation on the H2C with default filament placement on 1+3 AMS was 7.5hrs

Once again though - doing the allocation myself I got the time down by an hour to 6hr 30mins

The difference is only 2g more waste - for a reduced print time - So the auto allocation is not very impressive.

Also another issue is that I could only order 1 0.4 nozzle - so that to order a high flow one to get the full 6 x 0.4s

The printer doesn’t seem to want to use the high flow 0.4 at the same time as the other 5 - so is only using 1 + 5 nozzles.