Curved surface engraving now supported for H2D but not H2S?

Bambu Lab H2 Series
1

I noticed that in the latest BambuSuite update, curved surface engraving is now supported for the H2D but not the H2S (and it doesn’t work it throws an unsupported laser module error). Is there any hardware the H2D uses that the H2S does not have to support this?

2

Not sure, power to the toolhead? The H2D supports a 40w laser where the H2S supports only a 10W laser.

3

Please Chinese overlords sell me a rotary tool.

4

Maybe thats why theres a 4-pin cable on the inside of the printer…
I’m pretty sure they made a blog about H2 Laser accessories in the near-future, (my guess is that its) probably coming at the same time the H2C releases.

5

I would guess, this might also require a firmware update.

The fact they mention the H2D only, could be because the H2S wasn’t released yet when the wiki was written.

Not sure though. But I don’t see a reason to why this would be different on an H2S.

I have some print job running at the moment, but will test it on my H2D