I find that I am lazy, and when I print a second print in the same material, buth with a different colour, the AMS will always go to 250 C to load the filament ( even for PLA ) and sometimes even uses that for printing ! I need to manually reset the temp twice; before and after 1st layer inspection.
Would be good enough for me if I could use a hex editor and and add custom profiles in Studio and then be able to sync them to the AMS ( brandname and temps are now greyed out ).
No timelaps in LAN only mode, I know is a “registration” part of the webcam, but I have bought a seperate webcam for this…
Beying able to add cusom filements is what I miss the most as a feature at the moment…
thanx,
lucas.