Just to add an often overlooked feature regarding variable layer height:
- In the device settings (hover the mouse over the printer symbol in the upper left until the edit icon appears, then click it), in the Extruder section, you can change the effective min/max layer heights for variable layer height.
- I have run min layer height trials successfully down to 0.03mm. To be on the safe side, I tend to stick to 0.04mm nowadays (although the color mixing feature uses sub-layer heights down to 0.02mm but it can lead to issues due to speed increases which are neccessary at these layer heights).
- Going down below the defaults will significantly improve Silk appearance at the cost of print time.
& 