Drucker erkennt Anfang und Ende der X- und Y-Achse nicht

[CanDo]

It sounds like they are different versions of the X1C.
Were these purchased at the same time?
Do they have the same Lidar unit?

Bambu Lab micro lidar introduction and methods for distinguishing...

X1C - different Lidar hardware versions

Hi ! I was checking the Bambu Store and I noticed that there are 2 versions of a board, for 2 versions of Lidar, both in the X1C: Bambu Lab micro lidar introduction and methods for distinguishing versions(single red or dual red) | Bambu Lab Wiki I don’t know too much about Lidar other than the basic principle, and they are saying that there shouldn’t be functionality differences between them, but even in the article above on their Wiki, they class the dual-laser as Class 1 and the single-laser…