I couldn’t determine where to send feedback on wiki.bambulab.com.
At Recommendations for printing on the Cool Plate | Bambu Lab Wiki
It says PETG is supported for the cool plate. But after a recent update, that seems to no longer be the case.
https://www.reddit.com/r/BambuLab/comments/zpx7jn/petg_no_longer_supported_on_cool_plate/
The page should be updated to remove PETG and it would be nice if a note was added indicating early cool plates were marked as PETG, but that it is no longer recommended.
If you provide me with Wiki edit access, I’m fine to make this change myself.