Ever since firmware update today, I’ve had sidewall waste chute filament drops?
Like, it drops the purged filament on the left side of the waste chute. I’ve had to get pliers to pull it off.
2 Likes
Just had another one, this was waaay off.
I also just tightened up the belts last week so I know they’re not loose.
I’ll try retightening anyways…
Have you re-run calibration? I have had a similar issue randomly occur here and there and it was resolved after a calibration run… It wasnt that far off but more over the bed than the chute…
I did… waiting for it to happen again, but seems pretty random so far. Only happened the two times but I’ll pay attention more. Each time has been after a good 5 prints or so without a power restart between, so maybe just a runtime leak.