Excellent First Layer Adhesion - Now I just need bigger magnets

BambuLab was not kidding when they said the new gold Textured PEI plate had “Excellent First Layer Adhesion” however Im not so sure about their promise that it “Prevents warping with reliable magnetic adhesion”.

Polycarbonate 1 vs. Bambu Textured PEI Plate 0

and to think this is without glue …

I’ve had it happen with ASA+CF…

I’ve been doing some exploration wrt printing PC (and similar) without warping. Found this thread on prusa forum that you may be interested in, depending on how deep down the rabbit hole you want to go with this. Not tried the print settings myself yet so can’t comment on the usefulness.

PS: I am not responsible for any damage caused to your printer by following any advice from my post or linked resources