Since one of the last updates I’m unable to switch between PLA and PETG for example. Normally I could just select PLA and print, then select PETG and print again. But now I get the error that for example I can’t print PETG because it thinks that there is PLA on the external spool. I’m only using the external spool.
So now I have to manually select PETG on the external spool before I can print by going to Device → external spool and select a PETG filament.
2 Bambu studio versions back (still 2.0) it was working fine from the prepare page.
Anyone know how to fix this, because it is very annoying.
