Extra support around the tube on the print bed

[willem]

Hello,

I have a round tube that I want to print vertically, but I want extra support at the bottom of the print bed so that it stays in place better on the bed. And it cannot fall over or tip over.
in the photo the blue border is extra.
I use bambu studio

how to make the extra blue border

[william.e.lewis464]

You are looking for Brim type, width, and object gap, I’d also look into tree supports for the internal geometry

[willem]

thanks, i’ll try it.
Sorry for my bad English, it’s not my native language.

Great, it works, thanks William.

Kind regards Willem (Dutch)