Filament selection limited?

EDIT: Removing a filament and re-adding it made them all show up again. Just a little glitch. I’ll leave this up for anyone else who runs into the same issue.

I’m scheming my first H2D prints this morning, but was a little concerned to see no profiles beyond 5 basic bambu ones:

image

I should have the generics showing up:

I use Generic PLA for 99.9% of my prints since PLA basic tends to go too fast for my PLAs. Of course I can recreate it, but why are these not available for H2D?

2 Likes

Woah since when are there Fiberon profiles? I just did a bunch of projects with Fiberon PA6-CF this weekend and had to make my own profile