Filling problem

[Raffhal]

@EnoTheThracian

Well, temperature control is tricky in an oven. I have done it myself with the help of a meat thermometer for better temp control.
But I would not advise on doing so.
There are quite a few pic’s of accidentally melted spools here in the forum. I myself did manage to fuse filament strands together on a single spool (of a 12 spool load though).
There’s also the severe risk of running into trouble with the wife, housemates, etc…

Using the printers heat bed is much simpler even though it does mean that the printer is blocked for that time.
In the medium term, even a cheap drier is well worth it. I personally use an outdated Ensinia and a Sunlu S2. Quite happy with the S2 actually.

ok i try that, thank you for your help