Fine stringing on new filament

Bambu Lab A1 Series Troubleshooting
1

Hi

I’m new to the 3d printing game, but have heard a lot about stringing. However up until now I’ve not been seeing any and it’s all been fine using Bambu filament, however I just bought myself a couple of spools of of sunlu PLA and every print is seeing stinging. Nothing huge, but just loads of fluffy fine stuff that I need to burn off with a heat gun.

seems to happen mostly during bridged areas

Is this is moisture issue or something else?!

Are there any specific sunlu filament presets anyone knows of?

Thanks for your help!

2

Bambu’s default for printing filament is 220*
If it’s just PLA, set temp to 210*, if it’s Silk then 215*.

2 Likes
3

hi - thanks. which specific setting do I change this? (sorry - im very new to this :slight_smile: )

1 Like
4

01

02
02762×613 72.5 KB

If you decide to save the setting, it will add “COPY” to the end.
You can edit it to something else if you want.

2 Likes
5

Thanks for the help! :pray: