Firmware notification stopped my print

Bambu Lab P Series General Discussions
1

So, yesterday, near the end of a print I was doing (after manually swapping filament 2 times for a multi color print without AMS), I find my printer stopped, literally mid way through ironing the top layer of the 2nd of 6 objects on the bed.
On the screen it was asking if I wanted to run the next firmware update. Are you kidding me? what the ■■■■ is that?
Why would it stop mid print to ask me for a firmware update? Top it off, the 4 hour print was completely wasted. Because of this stop, Bambu studio seemed to have canceled my print, so I couldn’t just continue.

Anyone else run into this?

2

Not the P1S, but the A2L just pushed a notification for a firmware update 1.5 days into my print, canceled the print, and ruined half a kilo of filament. So That was lovely.

3

So not just me… ah well… Sorry to hear that. For me it wasn’t that bad, but still… They should have that kind of alert/notification happen only on idle. or at least wait till the job finishes…

1 Like
4

Yeah. Thankfully didn’t happen during a recent 6 day print. I think I’ll disconnect the internet when I do long prints, just in case.