Hello , I bought my first bambulab x1c . I had a k1 max but decided to change . I’m using default profile 0.08 mm extra fine to print a Batarang but I’m not happy about first layer . As you can see in the picture , there are a lot of lines and I would like to have a uniform bottom layer . First …

Hi Maybe this can be of a help: [image] Optimize a (almost) perfect first layer Bambu Lab X1-Carbon Hi Actually my Bambulab X1 prints PLA flawlessly, including the first layer. I never had trouble with the first layer (cool or hot plate). Recently, I tried to write on …

hello , thank you for you answer. did you try to play with z offset ? I’m using cool plate bed and I’m not able to low the z offset.

No, because I don’t see what value it would add. Increasing the flow should have a similar effect as keeping the flow and reducing the z-distance.

First layer x1 carbon

Bambu Lab X Series General discussions

T_guttata January 5, 2024, 2:31pm 2

Maybe this can be of a help:

To summarize: I invested some time for testing but was not able to completely remove the lines!