I notice the flow calibration/lidar measurements isn’t happening even if I have flow calibration checked off
I have updated to latest firmware 1.04.01… reset with power off and nothing.
Ok i figured it out… somehow the installed printer was the P1P even tho i have the X1. Im 100% sure i selected the X1 when I first installed it. so its confusing why it was using P1p profile
with X1 profile its all fine
one would think the printer itself would report the the model is wrong.
I believe it reports the wrong build plate install.
-Uman
2 Likes
I agree it should flag it when your about to send the plate