I knew this would be the case from the moment i saw how the front cover gets taken on and off to swap nozels, but one one the connector tabs just broke off the front plates and I cant have swapped nozels more than 6 times since getting the printer!
For something that is likely to be taken on and off so may times. the way you have to pry that front plate off every time doesnt feel like the best design 
its sheep buy another one! and take more careful next time I am able to take about mine a lot without breaking it
Maybe it’s time to redesign the front extruder cover by incorporating a magnetic closure system, similar to X1 series printers, and providing more space for the stock extruder lever… 
Using magnets seems much better. I heard there may have been some cases of them coming detached during high speeds. But Im sure that could have been rectified