Hi, since upgrading to firmware 01.08.05.00 and the latest Bambu Studio, I’ve noticed when I start to print that about half the time, even for the first print after a power cycle, the printer will skip the full bed levelling and only do the 5-point check despite having bed levelling ticked in Studio when sending the print job.
Out of 7 prints since yesterday it’s done this 3 times now. Is anyone else experiencing this? I can’t test right now due to a print in progress but I think it might be the case that any print job coming from Studio will skip the full bed level, but then when I re-print the job on the printer or via Bambu Handy, it will do the full bed level if I’m recalling the order of events from last night’s prints.