They were printed a few days apart. But I opened up my original file and just changed it to two walls. My chamber temp I don’t know exactly on these two prints. But I’ve been watching it very closely and I’m always between 33 and 36° C while printing PETG . I could not tell you the exact chamber temperature on both of these prints. I was having really bad warping with PETG to the point where I was using Nano polymer to get them to stick to the bed. It stuck so good it started to give me bubbles on my smooth PEI plate. After the new Beta release my warping went away and I’m printing with no glue at all and no warping.
On a side note if anyone gets bubbles on one of their PEI build plates. Put the plate upside down with the bubbles facing down on the bed, heat it up to 100° C and then shut off the bed and let it cool in the printer. All the bubbles went away.