H3C or BambuStudio Bug: Is drying temperature reduced during printing?

Summary

  1. Bambu Slicer says drying temperature will be reduced during printing
  2. Printer does not appear to lower drybox temp when printing from drybox.

Bambu studo 2.91.70 ubuntu 26 appimage
H3C 01.01.03.00
AMS3H 02.00.32.82

Full Information

I recently tried drying while printing.

Initially I put PETG into the drybox (slot 6) and started drying it at 65C (the recommended default). About 6 hours into the 12 hour drying cycle I needed to print. I then put the end of the filament into the feeder and the machine loaded it (still slot 6, still drying). I then printed. I received a message from Bambu Studio saying “Drying temperature is reduced during printing” (makes sense, warm filament may not able to be moved by the extruder precisely)

However after a few minutes I did not see the drybox temperature reading drop. I opened the AMS 3H drybox lid and it quickly dropped to 63C within about a 1/2 minute, but then I closed the lid and it quickly warmed up again to 65.