Hard to remove Polysupport

[SimEyeSee]

You just need a flat metal tool to push in between the support and PLA, it isn’t that hard to get off when you do that.

The tool I show in this post works very well to get in between.

Is the specialty support filament worth it?

I have been using the Bambu support material and I think it works well, but I haven’t tried using PETG yet. When you select the Bambu support for the support material interface a box shows up recommending to set: 0 top z 0 interface spacing Concentric pattern Disable independent support later height If you click yes on the box, it will set it for you. Most of the time it is easy to get off, but sometimes it is hard, especially when it’s supporting a flat surface. Make sure to wait until t…