Bambu Lab Community Forum

Hardened Nozzle

Bambu Lab A1 Series General Discussions

PrinterMcgee December 5, 2024, 8:57pm 2

As unlikely as it sounds this was just discussed.

Clarification question about stainless vs hardened hotends Bambu Filament and Accesories

I recently purchased a hardened steel hotend to use with the marble PLA I also bought. I’ve been wondering whether I should switch back to the stainless steel hotend when I print in regular PLA/PETG, or if I should just leave the hardened steel one in there full time. I tried searching online, and I’ve found a couple of conflicting suggestions. Some say there’s no reason not to leave the hardened in all the time, and others have said stainless is better for regular PLA/PETG because of temperatur…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled