Help: Print bed Moving down while extruding on calibration

I have never seen this before. During the flow calibration step the bed physically lowers while the nozzle is going over the left side. My first thought is that the bed leveling is off. Not sure if this affects the rest of the print however because it warns me about first layer defects. Benchy starting to print fine now. Using TPU Inland with Generic TPU Settings on engineering place X1C. It has printed ABS before and I don’t think anyone has cleaned it at all aside from the build plate.

Cleaned off Lidar and build plate and retried and worked perfectly. Not sure what happened. Kinda dug into my build plate too which sucks