Hello everyone; All of a sudden, an error message appeared stating that the homing of the Z-axis had failed. The bed only moved halfway up. The axes were free and the bearings were in the correct position. Even repeated switching off and on did not help. The printer is only one month old! How does …

Hello Barry, hello Jon, It works again. It had nothing to do with contamination, old filament residue or similar. The axles were clear, no hidden debris, the bearings were where they should be and the plate was clean and correctly positioned. The heating bed didn’t even come close to the nozzle, …

Bambu Lab Community Forum

Homing z-axis failed P1S

Bambu Lab P Series Troubleshooting

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled