Honeycomb Storage Wall Finally Done!

[highrise955]

@neolinux

Did you use infill?

On the page they say:

Printing settings

• layer height: 0.25 - 0.3
• perimeters: 3 (or more - without infill for faster printing)

I want to print it in 0.28 extra draft with no infill and 3 permiters, but the OrcaSlicer says that the print TIme is 2h…

I used the default settings. Not sure I would trust no infill due to the force needed to press some of the inserts into the honeycomb. 2 hours per tile is about right. Like I said, about halfway through each tile I bumped it up to Sport Mode.