Hotend sock broke off

Bambu Lab X1 Series Bambu Lab X1C
1

just had my hotend collide with a print, opened the magnetic door and knocked its socks off :slight_smile:

I’m about 150 hours in, how often does this happen? Just wondering so I can stock up on socks!

Edit: looks like the hotend is wacked out of sync, my next print has a terrible first layer. I have a few spare nozzles, looks like I’ll have to replace it. I’ve just watched a video on it, not too bad, have to deal with grease and wires a little.

2

Just replaced the hotend with another .4 I had purchased with the printer. Sort of a pain dealing with grease to chance the hotend. Sending my first print since we’ll see how it goes…