I cannot get clean ASA prints

Bambu Lab P1 Series Troubleshooting
3

Oh, that is a very detailed answer and a lot of knowledge here. This is very kind of you, tweaking the file and printing it. Thank you.

I only have textured PEI board. I will try :

  • Preheating (although P1S have a bed temp max at 100°C)
  • Glue.
  • Your file.

I’m a little concerned about speeds honestly, since my ASA is rated for 30-50 mm/s, but I’ll try anyway :slight_smile:

I’m curious to see (tomorrow, now :slight_smile: ) what it does. I’ll come back with the results.

Thank you again.